|
Home / Executing Simulation / Viewing Convergence and Intermediate Results
Viewing Convergence and Intermediate Results
The numerical values such as errors in nonlinear calculation are displayed in a graph, which indicates the convergence state.
Some analyses have function to show graph automatically. But, a graph will not be shown if adaptive meshing is applied.
Result can be opened during the simulation if the analysis outputs the intermediate results.
|
Item |
Notes |
|
Tab |
Tab will be shown for each item such as nonlinear error. By clicking tabs, items for viewing will be switched.
|
|
Intermediate Result (Field) |
Intermediate result field can be opened during the simulation if the analysis has function to output the intermediate results. If the button is pressed again during the simulation while the field is opened, intermediate results will be updated.
|
|
Intermediate Result (Table) |
[Table] can be opened during the simulation if the analysis outputs the intermediate results. |
|
Abort |
The simulation will be aborted. It is the same function as the <Esc> key. |
|
Estimated remaining time |
Based on the elapsed time, the estimated remaining time for calculation is shown. |
|
Estimated finish time |
Based on the estimated remaining time, the estimated finish time is shown. |
At the end of analysis, the graph will be closed automatically.
To reopen the graph, go to the [Model] tab.
Click ▼ at [Run Mesher/Solver] 
.
And select [Convergence status] 
.